Kaan Gideroğlu1, Serdar Toksoy2, Mithat Akan3, Serkan Yıldırım, Emin Sümbüloğlu, Tayfun Aköz

1Department of Plastic and Reconstructive Surgery, Medicine Faculty of Abant İzzet Baysal University, Bolu, Turkey
2Department of Plastic and Reconstructive Surgery, Dr. Lütfi Kırdar Kartal Training and Research Hospital, İstanbul, Turkey
3Department of Mechanical Engineering, İstanbul Technical University, İstanbul, Turkey

Keywords: Tendon lengthening; lengthening properties; biomechanical comparison.

Abstract

Objectives: Clinically, the Z-plasty lengthening is the only method used in the upper extremity, whereas several different techniques such as the Vulpius and Baker are used in the lower extremity. In this study, the usage of the modified Vulpius and Baker tendon lengthening techniques in the upper extremity was investigated. Materials and methods: Vulpius and Baker techniques are modified by changing their application site in 90 sheep fore-limb deep flexor tendons using three randomly divided groups. Z-plasty, V-Y-plasty (Modified Vulpius) and U-T-plasty (Modified Baker) techniques were used in groups I to III, respectively. Their elongation and biomechanical properties were compared.
Results: The Z-plasty technique provided significantly greater lengthening than the other two techniques, followed by the U-T-plasty technique. Failure load of the U-T-plasty technique was 60.7% higher than the Z-plasty technique and 45.4% higher than the V-Y-plasty technique. Repairs with the U-T-plasty and V-Y-plasty techniques were significantly stiffer than the repairs with the Z-plasty technique.
Conclusion: The U-T-plasty technique may be a good alternative to the Z-plasty technique because of its easy application and better biomechanical properties, especially in cases that need moderate-sized elongation and early mobilization. But the restorative properties of this technique need to be observed on an in-vivo model.